SOMFY 1115202, Руководство по установке

Страница: 14 / 80

Copyright © 2009 Somfy SAS. All rights reserved.
Sunea CSI RTS
12
EN
3. Installation
The Sunea CSI RTS must be installed in a location sheltered from inclement weather.
3.1 Motor preparation
Fit the crown (A) and the drive wheel (B) to the motor. 1)
Measure the lengh (L1) between the base of the motor 2)
head and the end of the drive wheel.
3.2 Tube preparation
Cut the roller tube to the required length. 1)
Deburr the roller tube and remove the swarf. 2)
For smooth roller tubes, cut a notch with the following 3)
measurements: e = 4 mm;
h = 28 mm.
3.3 Motor/tube assembly
Slide the motor into the roller tube. 1)
For smooth roller tubes, position the notch previously cut
on the crown.
For safety reason, fix the roller tube to the drive wheel
2)
with 4 self-tapping screws with a diameter of 5 mm or 4
steel pop rivets with a diameter of 4.8 mm located:
at least 5 mm from the far end of the drive wheel: -
L1 - 5, and
no more than 15 mm from the far end of the drive -
wheel: L1 - 15.
The screws or pop rivets must only be attached to the drive wheel and not to the motor.
3.4 Fitting the emergency crank
Use an awning eye fitted with a 6 mm square pin (C) or -
7 mm hexagonal pin (D) (accessories not supplied).
Attach the appropriate crank handle to the motor head.
-
3.5 Fitting the tube-motor assembly
Fit the tube/motor assembly to the end bracket (E). 1)
Fit the tube/motor assembly to the motor bracket (F) 2)
output cable down (G).
1
2
A
B
L1
L1 = …
Ø > 47
1
3
2
e
h
15 mm
5 mm
L1
1
2
20 mm
D
C
2
1
E
F
G