SOLZAIMA K50, Инструкция по эксплуатации

Страница: 30 / 64

29
The pellets are fed through the supply channel to the burning pot (combustion
chamber), where they will be ignited using an igniter. This process may take 5 to 10
minutes, depending on whether the worm screw used to push through the pellets has
been previously filled or not. Once the ignition phase is completed, the message "On"
appears on the display. The heating power can be adjusted at any time by pressing the
power selection button for approximately 1 second. You can select from the five pre-set
power levels that are available. The selected power is indicated on the display. The
initial power status at each start-up will correspond to the power level set before the
last stop
Note importante : Before starting the machine check that the baffle plate
is correctly positioned .
9.1. Stop
The stop order of the device is carried out by pressing the ON / OFF button for 3s.
The display will show “Desativação” (Disabling) until full completion of this phase.
The extractor will operate until the fume temperature of 64ºC is reached, to guarantee
that all the material has been burnt.
9.2. Turning Off the Unit
You should only switch off the appliance after you have completed the shutdown
procedure, make sure the display shows "Off". If necessary, disconnect the
Power supply
10. Instruction for Installing the Casings
Before proceeding with the installation of the display should immediately check if the
packaging where the display is located is in perfect condition, any damage should be
reported and reported before proceeding with its installation.
The installer to proceed with the assembly of the display must have available:
Figure 14 –Material required for the installation of enclosures near the wood stove
wrench tool Nº 10