•
USB Flash Drive (USB Key) can be inserted only in the
Flash
port.
•
For details on changing USB storage devices, see the following section.
3. Connect the supplied power adapter to a power outlet and plug the power cord into the inter-
NAS/USB's
Power
input on the rear panel.
4. Power on.
Locate the interNAS/USB's power switch on the interNAS/USB's rear panel. Press it once to power on
the interNAS/USB.
5. The interNAS/USB's self-test.
The interNAS/USB will run a brief self-test (2 or 3 seconds). During the self-test, all of the inter-
NAS/USB's LEDs will be illuminated or flashing.
6. Booting up.
When the self-test is complete, boot up will start. The
Ready
LED will blink continuously, and the
LAN
LED will blink occasionally. Boot up should take approximately 1-3 minutes. It will take longer
on the first boot up, and on any boot up following an improper shut-down.
7. Boot up completed.
When the
Ready
LED stops blinking, and remains on, boot up is complete. If the
Status
(Orange) LED
stays on, or if the interNAS/USB repeatedly beeps, there is a hardware problem. Consult the Trouble-
shooting section of this User Guide for possible solutions
Shutdown
The interNAS/USB must be shutdown correctly:
•
Press the power switch and hold it down for 3 seconds to start the shutdown sequence.
•
The
Ready
LED will blink during the shutdown.
•
When all LEDs go out, the shutdown is complete.
Page 10
