
User Manual
18
20
The front filter serves as the air inlet; the filter
on time to keep the chamber clean.
1. Turn counterclockwise to unscrew and take down
it with warm soap water;
2. Install the filter screen
Tighten clockwise the screws to fix the filter ;
3. Make sure the filter is installed before use of the microwave oven;
4. The factory setting has the function to remind the user of washing the filter
(6) Splash shield cleaning
1. Detaching: Hold the two buckle positions in front of
hands (as shown by the arrows). Exert your strength following the direction of
the arrows and pull downwards after you have pulled out the buckles:
2. Wash the splash shield:
3. Installation: Pick up the splash shield and obliquely put it into the chamber in
pin at the rear into the positioning hole on the rear
plate of chamber, then push the other side to insert all positioning pins into their
Caution!
Make sure the splash shield is installed
correctly before use of the microwave oven!
Filter Filter screws
Filter cleaning
should be cleaned
the filter ; and wash
the splash shield with your
the way that insert the first
positioning holes.
every 30 days.
The front filter serves as the air inlet; the filter should be cleaned on time
to keep the chamber clean.
1) Turn counterclockwise to unscrew and take down the filter; and wash it
with warm water.
2) To install the filter screen, tighten the screws clockwise.
3) Make sure the filter is installed before use of the microwave oven.
4) The factory setting has the function to remind the user of washing the
filter every 30 days.
Splash shield cleaning
1) Detaching: Hold the two buckle positions in front of the splash shield
with your (as shown by the arrows). Exert your strength following the
direction of the arrows and pull downwards after you have pulled out
the buckle.
2) Wash the splash shield.
3) Installation: Pick up the splash shield and place it into the chamber
so that the first pin is aligned with the hole on the rear plate of the
chamber. Then push the other side to insert all positioning pins into
their respective holes.