Solter COTT-135, Инструкция по эксплуатации

Страница: 12 / 47

INTRODUCTION
Thank you for choosing our brand, we hope that the welding machine you have purchased will serve
you well.
This instruction manual contains the necessary information and warnings for correct use within the
maximum operator safety conditions.
INVERTER welding equipment must be used by expert personnel who know and understand the risks
involved in the use of this equipment.
If you have any doubts or queries concerning this manual please contact us. Internal manipulation of
the equipment involves the risk of electric shocks. We request you not to carry out any manipulation of
the equipment. Only technically trained personnel can do this.
Solter Soldadura denies all responsibility for negligent practices in the use or manipulation of this ma-
chine.
This manual must be kept with the equipment purchased.
It is the responsibility of those persons who use and repair this machine to comply with the require-
ments of the above mentioned regulations.
SAFETY AND PROTECTION
ELECTRICITY
The correct operation of the machine can be ensured through its correct installation. Verify
that the electric current (V) of the equipment corresponds to that of the electricity supply.
ALWAYS connect the earth terminal (T).
Those persons carrying electronic body implant devices (PACEMAKERS) must not use
equipment of this type.
PERSONAL CLOTHING
The entire body of the welder is subject to possible contact with aggressive agents and so
must be totally protected. Use safety boots, gloves, oversleeves, gaiters and leather aprons.
BURN PROTECTION
Never touch parts of the wire or the material with your bare hands once soldered. Avoid skin
contact with airborne particles. Do not point the torch at any part of the body.
EYE PROTECTION
Welders and their assistants must use safety masks or goggles with filters which stop harm-
ful radiation entering the eyes. Use special and screens if possible to observe the welding
area during the process.
FIRE PROTECCIÓN
The welding process produces flying incandescent metal parts which may cause fires. Do
not use the machine in areas where there may be inflammable gases. Clean the working
area of all inflammable material. Pay special attention to the protection of the gas cylinders in
accordance with the necessary requirements.
PROTECTION FOR GAS CYLINDERS
Cylinders containing gas (fire extinguishers etc.) store their contents at high pressure. If
these suffer any form of damage they may explode. Always treat these cylinders with care
and weld as far away from them as possible
WELDING IN TANKS WHICH MAY CONTAIN THE TRACES OF INFLAMMABLE MATERI-
ALS INSIDE INVOLVES A HIGH RISK OF EXPLOSION. WE RECOMMEND KEEPING AN
EXTINGUISHER READILY AVAILABLE FOR USE.
SOLTER
SOLDADURA S.L.
INVERTER 1