SoloStrength speedfit frame, Руководство владельца и по безопасности

Страница: 14 / 20

14
ASSEMBLY MANUAL
SPEEDFIT FRAME
•
•
Slide Item 9 into Items 3 & 5, and install 1/2” screws as shown on the left (four screws).
Repeat on the opposite side.
STEP 3
Check Point 1: Be sure that the screw head is
flush with the extrusion. If not,
Item 2 will not move smoothly.
Check Point 2: The bent tab on Item 9 should
face inward.
9
9
Check Point: The bent tab on Item 8 should face inward.
•
•
Insert Item 8 into the slot in Items 3, 4, 5 & 6
Install 1/2” screw. See the illustration on the left as an example. Look to the exploded view
in Box Contents , page 8, for the location of all four Items 8 (two on the top, two on the
bottom).
STEP 4
8
3
•
•
Attach Item 7 to the previously-installed Item 8 using an
acorn nut and a round-head screw. Do not tighten; let
Item 7 move freely. Refer to the cross section diagram
on the right.
Repeat this in the remaining five locations where Items
8 & 9 were installed in Steps 4 & 5.
STEP 5
3
7
8
3
7
8
3
9
5