CSE-H25 User
’
s Manual Ver. 1.2
Sollae Systems Co., Ltd.
- 11 -
http://www.sollae.co.kr
2
Getting Start
2.1
Installation Method
You can install CSE-H25 in the following steps.
Table 2-1 CSE-H25 Installation steps
Title
Item
Sub-item
1.
Checking the
communication
environment
Check items
IP address environment
Serial port parameters
Application program to be used
2.
Connecting to
the network
Check
method
Check the LINK LED
3.
Configuring
the
environmental
parameters
Configuration
method
Set by ezManager, a utility program for configuration
through the network.
Set by AT commands in ATC mode
Configuration
items
IP address related items
Serial port related items
Communication mode (depending on application
program)
4. Application to the field
2.1.1 Checking the Communication Environment
Before installing CSE-H25, check the network environment where CSE-H25 is to be
installed, including the followings matters:
IP address environment (local IP, subnet mask, gateway, DHCP/PPPoE etc.)
Serial port type of the equipment to which CSE-H25 is going to be connected (RS232)
Serial port items of the equipment to which CSE-H25 is going to be connected (baud
rate, data bit, parity, stop bit, flow control)
Application program protocol to be used (TCP/UDP, server/client, etc.)
