CIE-M10A User Manual Ver. 1.0
- 14 -
1.5.6 Ethernet Interface
An RJ45 connector is for the network interface of CIE-M10A. You can use a UTP cable. It
automatically senses 10Mbits or 100Mbits Ethernet. It also provides auto MDI/MDIX
function that can automatically sense a 1:1 cable or cross over cable.
Each Ethernet device has its own hardware address (MAC address). CIE-M10A is shipped
to the market with the hardware address set in the factory.
Figure 1-12 the RJ45 connector
1.5.7 RS232 Port (DB9M)
There is a UART port which is 3.3V level. This port provides serial to TCP/IP converting
function working independently with its I/O ports. This port supports RTS/CTS flow control
function. The RTS informs to the counter part that its receiving buffer is free and is ready to
get data. And CIE-M10A gets CTS information from the counter part
’
s RTS.
Parameters
Supported Values
Baud rate
300 ~ 230,400 bps
Data bits
8, 7, 6, 5
Parity
None, Even, Odd, Mark, Space
Stop bit
1, 1.5, 2
Table 1-4 supported values of the RS232 port
