105
104
12. Empty the blender jug and clean the blender jug with the blade base and lid as
well as the cap as soon as possible to prevent the food from drying.
n
IMPORTANT SAFETY NOTES DURING USE
•
If you want to use the tamper to push the foods in the blender jug down
towards the blade base, you must only do this when the lid is in place through
the opening in the lid. Of course, to do so, the cap has to be removed before-
hand.
Note:
The tamper can only be used in the 2-litre-jug. While using the tamper,
an interruption of the blending process is not necessary.
•
Only use the appliance while the lid is shut. If you want to add liquid or food
through the opening in the lid, do it slowly to prevent the jug contents from
splashing out.
Caution:
Never remove the lid during blending to add food!
When doing this, the appliance has to be switched off and the plug has to be
pulled first. After that, lift off the blender jug, add the food and only then place
the closed blender jug back on the motor base and start using it again.
•
Always respect the MAX marking on the blender jug and do not blend too many
solid or hard foods in one blending cycle, as this might cause the motor overload
resp. overheat protection to switch off the motor.
•
Place a hand on the lid if the jug should be filled in such a way that the contents
reach almost or exactly up to the MAX marking.
•
When taking the blender jug off of the motor base, the appliance automati-
cally switches off through the safety switch on the motor base. All settings are
deleted. In this case, place the blender jug back on the motor base and make
the settings again.
•
If possible, always touch the function buttons in the center to avoid touching
two buttons at once. If two or more buttons are touched, the appliance auto-
matically switches off and „ERR“ shows up in the display. In this case, pull the
power plug, reconnect it and restart the appliance.
•
Always unplug the blender while it is not in use or before it is disassembled,
cleaned or stored away.
OVERLOAD AND OVERHEAT PROTECTION
Warning:
To protect the motor, please refrain from using the appliance any longer
once the automatic overload and overheat protection has been triggered
and „ERR“ is displayed.
In this case, switch the appliance off, pull the power plug and remove the blender
jug. Wait 20 minutes to let the appliance cool down. After these 20 minutes, you
can replace the blender jug on the motor base. Then, plug the power plug back
into the power outlet and restart the appliance.
If the motor has cooled down enough, your appliance will restart and you can
keep using the blender as described in this manual.
The motor can overload if the blender jug has been too heavily filled or if it has
blended for too long. In this case, reduce the amount of ingredients or repea-
tedly pause during blending to allow the motor to cool down in order to prevent
overheating.
Complying to the MAX marking reduces the risk of overloading the motor.
However, especially hard foods might still cause an overload. If you notice the
motor stalling or running slowly, only blend for 10 seconds at a time or reduce
the amount of ingredients. Also, adding liquids might loosen up a tough mixture.
m
