moisture, heat and naked flames. Keep the appliance away
from moving parts or appliances.
7. Never carry the appliance by the power cable and do not place
it on the power cable. Never pull on the power cord to discon-
nect the appliance from the power mains.
8. We recommend that you do not use an extension cable with
this appliance. Do not place the appliance directly underneath
a power socket.
9. Unplug the appliance when it is not in use or unattended and
before cleaning. We recommend the use of a residual current
device (RCD safety switch) to ensure additional protection
during the use of electrical appliances. It is advisable to use a
safety switch with a rated residual operating current of 30 mA
maximum. For professional advice consult an electrician.
10. Do not make any adjustments to the appliance, cable, plug or
accessories.
11. Do not leave the blender unattended when in use. Incorrect
use may cause injury!
12. Never take hold of an appliance that has fallen into water.
Always take the plug out of the power socket before removing
the appliance from the water. Do not use the appliance again
until you have had it‘s ability to function safely checked by Solis
or a Solis approved service centre.
13. Never place the blender in a place where it could fall into water
(e.g. next to a sink).
14. Place the appliance so that it is never exposed to direct sun-
light.
15. Never put sharp or pointed objects and tools into the appliance
openings. The appliance may become damaged – danger of
electric shock!
16. Do not shake or relocate the appliance while it is in operation.
s
IMPORTANT SAFETY PRECAUTIONS
Please read through this user manual thoroughly before
using your Solis Mix & Go Blender, so that you become
familiar with your appliance and can use it safely. We thor-
oughly recommend that you keep these instructions and, if
you pass the appliance on, that you also hand these instruc-
tions to the new owner.
For your own safety, please observe the following safety
measures when using elec trical appliances:
1. To prevent electric shock, neither the motor base nor the
power cord or plug must come into contact with water or other
liquids. Water can enter the housing and damage the appli-
ance! Should the motor base resp. the power cord or plug
come into contact with liquids, use dry rubber gloves to pull
the power plug from the socket.
2. Do not operate or unplug the appliance with wet or moist
hands or feet.
3. Before using the appliance, check that the voltage stated on
the appliance matches your mains voltage.
4. Place the appliance while in function on a solid, stable, clean,
dry and moisture resistant surface, like a table or a worktop.
Vibration during operation may cause the appliance to move.
Therefore do not place the blender near the edge of a bench
or table during operation. Do not use the appliance outdoors.
5. Do not leave the power cable hanging over table edges so that
it can be pulled. Make sure that it does not come into contact
with hot surfaces, such as hotplates or a radiator, or that it
comes into contact with the appliance. Fully unwind the cord
before use.
6. Keep the appliance away from hot gas, hot ovens and other
heat-emitting appliances or heat sources. Never use the appli-
ance on a hot or wet surface. Never place the appliance near
54
55
