2
2
Rear panel
Rear panel
. Connections.
. Connections.
Figure 1: Back view of the MiniMIxer
POWER SUPPLY
1
Minimixer works with an external power source,
using
a
tubular connector (pin + / 2mm). The
power supply is a switching
90/240V 50/60Hz -
12V/1A
.
USE ONLY THE ORIGINAL POWER SOURCE
SUPPLIED BY SOLIDYNE.
MiniMixer do not have ON/OFF switch. It remains
turned on if the power supply is plugged
(and
feeding from AC outlet).
TALLY LIGHT
2
It is a tubular connector (pin + / 2.5mm) for the
ON-AIR signaling light. Delivers 12VDC and sup-
ports a maximum load of 200mA. When the tally
light is plugged, the headphone output # 1 is muted
each time the light is turned on.
AUDIO USB
3
USB connection gives one stereo digital audio
input/output
on the computer. Uses a standard
USB A/B cable.
Be sure to place the CPU as close to the console as
possible to use the USB cable supplied with the
console. If necessary, longer or extension cables
can be used; but it is recommended not to exceed
4 meters. Always use good quality cables.
To connect USB port proceed:
1. Connect the power supply.
2. Plug the USB cable to the MiniMIxer.
3. Plug the USB cable to the computer.
Make sure the computer has an effective ground before
connecting the USB
If the equipment is not properly grounded, the USB input on
the console or computer could be damaged.
The computer must run Windows
©
7/10 or newer.
The OS will detect a new USB device and automati-
cally will install one
“USB playback device”
(at the
console’s side is the USB stereo input) and one
“USB recording device”
(at the console’s side is
the USB stereo output). The recording device re-
ceives the PGM signal.
MICROPHONES
4
The MiniMixer has
four balanced inputs
for
dy-
namic microphones
, using XLR connectors.
MIC 3 and MIC 4 inputs share the same fader.
When using both inputs, it is a good idea to use mi-
crophones of the same make and model.
HEADPHONES
5
There are 4 headphone outputs, using 1/8” TRS
(minijack). The level for all outputs is controlled
with one knob located on the section CUE MONI-
TOR.
The headphone output
#1
can be used to connect
powered loudspeakers. If a tally light is connected
to MiniMixer, headphone output #1 is muted when
the tally light turns on (mics on air).
POTS
6
RJ11 connector to land lines (2 wires). The pre-
set
NULL
allows to adjust the hybrid's rejection.
MiniMIxer
broadcasting mixing console
Page 7
