Solid State Logic ORIGIN, Руководство пользователя, Страница: 43 / 56

ORIGIN User Guide
Appendix A
37
Clearing ALL Routes/Crosspoints Quickly
The SHIFT/CLEAR ROUTE function also works with Range Selection s. So a very quick way to clear all console routing from
all Channels to all Track Buses is to press and hold the SHIFT switch to put the console into CLEAR ROUTE mode and
simultaneously press the Track Bus 1 and Track Bus 16 switches in the centre section, this will clear all routes from Track Buses
1 to 16, i.e. all Track Bus routes/ Crosspoints .
Routing LED Status Summary
A table of Track Bus and Path LED statuses.
LED Status Path ROUTED TO BUS LED Track Bus LED
Off No Path Routing No Paths Routed to Bus
On (Flashing) Path to Bus Routing Active Bus to Path Routing Active
On (Bright) Selected Path when Bus Routing Active Selected Bus when Path Routing Active
On (Dim) Path Routed to Bus Path Routed to Bus
Incremental Channel to Bus Routing
There is a shortcut to setup single Channel to single Bus routing (e.g. Channel 1 to Bus 1, Channel 2 to Bus 2 etc.) which may be
useful if working with multiple channels to a recorder attached to the Buses.
- Press and hold Channel 1 ROUTE key
- Channel 1 now selected, blinking
- Press and hold Channel 16 ROUTE key
- Channel 1 to Channel 16 now selected, all blinking
- Keep holding both switches down for 3 to 5 seconds
- Channel 1 to Channel 16 ROUTE LED s will blink faster
- 1 to 1 incremental routing is made for the selected range.
NOTE: This incremental routing will override any existing Channel to Bus routes for the selected range.
Additionally, there is an option to change the way the incremental routes are made. The default is that the incrementally routed
Bus follows the Channel Selection, i.e. if a range of Channel 9 to Channel 16 is selected, then the Bus Routing will be Channel 9
to Bus 9, Channel 10 to Bus 10 etc. to Channel 16 to Bus 16.
This default routing can be amended using the Incremental Routing Setup option (See Page 39). With the optional setting, the
incrementally routed bus defaults to starting at Bus 1 and increments from there. i.e. using the previous example, if a range of
Channel 9 to Channel 16 is selected, then the Bus Routing will be Channel 9 to Bus 1, Channel 10 to Bus 2 etc. to Channel 16 to
Bus 8.
Latching/Momentary Key Function
The Routing keys have a similar automated latching/momentary feature to the Comms/Talkback switches, i.e. a fast press will 'latch'
the key, a longer press will make the key momentary.