UNPACKING THE WATER COOLER
1.
Cut and remove the straps from the box. DO NOT turn the box upside down, or lay it on
its side. The bottom of the box is separate from the top section. Lift straight up on the top
box section to remove the top box section. Remove the Styrofoam packaging and plastic
bag. Lift the water cooler off the bottom of the box. Wipe it clean if necessary.
2.
Place the machine on a hard, flat surface. Make certain the unit is level. The unit should
not be close to direct sunlight or other source of heat.
3.
It is best to place the water cooler in an area with good air circulation. Make sure there is
at least 4 inches (10cm) of space between the back of your water cooler and the wall.
Keep a minimum distance of 2 inches (5cm) on each side of your water cooler.
WARNING:
The drain cap on the back of the unit may become loose during shipping. Fasten
the drain cap tightly before you start to operate the unit. If the drain cap is loose, the unit may
leak and cause floor damage.
PREPARING THE WATER COOLER FOR USE
The Aqua Sub is different from a traditional water cooler. The water bottle does not need to be
placed upside down on the top of the unit. The water bottle is placed in the lower cabinet of the
unit, and then a pump draws the water up to the dispenser.
Figure 1
Figure 2
Содержание AQUA SUB Aqua Sub MW-59
Страница 4: ...PRODUCT DIAGRAM ...
