3
Note: In order to maintain FCC compliance, use of a shielded Ethernet
cable with Skyway 5000 is required.
D.
A
NTENNA
The omnidirectional antenna of the SkyWay 5600 must be connected to the
base station prior to use.
1.
Attach the N-type coax coupler (supplied) to the N-type
connector at the top of the SkyWay 5600 enclosure
2.
Attach the omni antenna to the coupler.
3.
Wrench tighten both connections
4.
Wrap all connections with coax sealing tape (supplied)
The sectoral antenna of the Skyway 5700 antenna is shipped fully
integrated to the radio unit.
E.
I
NSTALLATION
After locating and installing the radio mast, the physical installation of your
Skyway 5000 radio can begin.
If benchtesting the system first, you may
want to skip this step and return to it after testing is completed.
1.
Using the clamp on the mast mounting kit, attach the SkyWay
radio to the chosen mast. Wrench tighten mast clamp bolts.
2.
Using the two axis adjustment pivots, point the radio antenna
in the general direction of the target radio. Partially tighten
axis bolts so that fine-tuning can be performed later.
3.
Connect RJ45 connector to the SkyWay radio.
4.
Slide cable gland up the Ethernet cable to radio housing and
screw gland into threaded opening. Wrench tighten, but do
not overtighten the nylon gland.
5.
At opposite end of gland (pointing away from the radio),
tighten seal nut against Ethernet cable. Wrench tighten, again
being careful not to overtorque the gland.
6.
Place PoE Injector and Power Supply in a convenient, indoor
location near to the destination hub, switch or PC.
7.
Route and connect outdoor Cat5 cable to PoE Injector.
8.
You may now plug in the Power Supply to power the unit.
