Sole Fitness E55, Руководство пользователя, Страница: 26 / 38

24
GENERAL MAINTENANCE
1. Wipe down all areas in the sweat path with a damp cloth after each workout.
2. If a squeak, thump, clicking or rough feeling develops the main cause is most likely one of
two reasons:
I. The hardw
installed during assembly need to be tightened as much as possible. It may be
necessary to use a larger wrench than the one provided if you cannot tighten the bolts
noise issues can be traced to loose hardware or the rear rails being dirty.
II. Dirt build-up on the rear rails and polyurethane wheels are also a source of noise.Noise
from build-up on the rails can cause a thumping sound that you would swear is coming
tubing of the frame. Clean the rails and wheels with a lint free cloth and rubbing
alcohol. Stubborn build-up can be removed with your thumbnail or a non-metallic
scraper, like the back edge of a plastic knife. After cleaning, apply a small amount of
3. If squeaks or other noises persist, check that the unit is properly leveled before calling the
service department.
MAINTENANCE MENU IN CONSOLE SOFTWARE
The console has built in maintenance/diagnostic software. The software will allow you to
when a key is pressed for example. To enter the Maintenance menu (may be called Engineering
mode, depending on version) press and hold down the Start, Stop and Enter keys Keep holding
the keys down for about 5 seconds and the message window will display “Engineering mode”.
Press the Enter button to access the menu below. Press the Level up and down keys to navigate
the menu.
A. Key Test - Will allow you to test all the keys to make sure they are functioning
B. Display Test - Tests all the display functions
C. Functions - Press Enter to access settings, use Level Up/Down keys to scroll
I. Sleep Mode - Turn on to have the console power down automatically after 30 minutes of inactivity
II. Pause Mode
III. ODO Reset - Resets the odometer
IV. Units - Choose from English or Metric display readings
V. Beep-
VI. Motor Test - Continually runs the tensioning gear motor
VII. Exit
D. Security - Allows you to lock the keypad so no unauthorized use of the machine is allowed. When the child
lock is enabled, the console will not allow the keypad to operate unless you press and hold the Start and
Enter buttons for 3 seconds to unlock the console.
E. Factory Settings - Access only allowed by manufacturing
Incline Calibration: If there is a problem with the incline, try running the calibration. Press the
Incline Up key and the Start key at the same time. Hold them down for 5 seconds and the Incline
calibration will start and run automatically. If the problem persists contact Sole service
department.
E55 / E95 ELLIPTICAL
.