14
SOLATHERM
reserves the right to modify characteristics of the products or their accessories and components without prior notice.
6.
Collector and Tank installation on the Mounting Structure
6
Tighten No.6 with No.1
after collector is fixed
on
6
Install the Collector and Secure it with the Lower and Upper Collector Support Brackets No.6 as indicated in the drawing
above using M8x20 bolts and washers, and tighten upper Collector Support Bracket Nr.6 with Support brackets Nr.1.
Install the Tank making sure the cold-water inlet is on the left side when looking at the system from the front.
Connect the Tank to the Mounting structure through the Tank Support Brackets as indicated on the picture above
using
M8x20 bolts through the middle strip’s hole
into the tanks rivets.
At
ten
ti
o
n
:
This sid
e
o
n
t
h
e
left
Choose the most convenient
holes
provided
on
the
horizontal
brackets
No.2
(preferably on the edges and
center) and secure the system
to the ground using the six
plastic anchors and anchor
screws M8x60 provided.
