17
SOLARIS® HITMAN230™
Disconnect the fixture from mains power and allow to cool completely before cleaning or
servicing. Service fixtures in an area where there is no risk of injury from failing parts, tools
or other materials. Excessive dust, smoke fluid, and particle buildup degrades performance,
causes overheating and will damage the fixture. Damage caused by inadequate cleaning or
maintenance is not covered by the product warranty.
CLEANING
The cleaning of lenses must be carried out periodically to optimize light output. Cleaning
schedules for lighting fixtures vary greatly depending on the operating environment. It is
therefore impossible to specify precise cleaning intervals for the fixture. Environmental fac
-
tors that may result in a need for frequent cleaning include:
• Use of smoke or fog machines.
• High airflow rates (near air conditioning vents, for example).
• Presence of cigarette smoke.
• Airborne dust (from stage effects, building structures and fittings or the natural environ
-
ment at outdoor events, for example).
If one or more of these factors is present, inspect fixtures within their first 100 hours of oper
-
ation to see whether cleaning is necessary. Check again at frequent intervals. This procedure
will allow you to assess cleaning requirements in your particular situation.
Use gentle pressure only when cleaning, and work in a clean, well-lit area. Do not use any
product that contains solvents or abrasives, as these can cause surface damage.
CLEANING THE FIXTURE
1. Disconnect the fixture from power and allow it to cool for at least 10 minutes.
2. Vacuum or gently blow away dust and loose particles from the outside of the fixture and
air with low-pressure compressed air
3. Clean lenses by wiping gently with a soft, clean lint-free cloth moistened with a weak de
-
tergent solution. Do not rub the surface hard: lift particles off with a soft repeated press. Dry
with a soft, clean, lint-free cloth or low pressure compressed
air. Remove stuck particles with an unscented tissue or cotton swab moistened with glass
cleaner or distilled water.
4. Check that the fixture is dry before reapplying power.
MAINTENANCE
WARNING! READ SAFETY INFORMATION ON
PAGE 3 BEFORE SERVICING THE FIXTURE.
Содержание HITMAN 230
Страница 1: ...USER MANUAL...
