SOLARFOCUS octoplus, Руководство по установке

Страница: 38 / 48

Electrical connection
38 Installation manual octo
plus
7.2 Power supply
A separate power circuit is to be provided in the boiler room / boiler installation room for the heating system;
mains connection: 230 V AC / 50 Hz C13 A
Specification for the mains connection cable (e.g. in case of replacement): cable SIHF-J 3x1.5 mm²
7.3 Connections required for installation
Connection Name of the component
X1 230 volt boiler plug
X3 Suction turbine
X4 Ignition device (glow pencil)
X16 Ash roller
X19 ID fan
X20 Overtemperature reset (OTR)
X23 Feed motor
X24 Motors for heat exchanger cleaning
X26 Primary supply air holding magnet
X27 Ignition supply air holding magnet
X30 Tank temperature sensor top
Connection Name of the component
X31 Tank temperature sensor centre
X32 Tank temperature sensor bottom
X33 Feeder temperature sensor
X34 Flue gas temperature sensor
X45 Lambda sensor
X47 Speed measurement ID fan
X48 Door contact switch
X49
Filling level sensor (intermediate pellet
store)
X53 Touch display connection
7.4 Connecting the control to the internet
To connect the boiler control to the Internet, connect the Ethernet port X2 (type RJ45) on the back of the display

28
to a network router via cable. The connection is required in order to use the following functions:
- mySOLARFOCUS app
- Weatherman function
- IP-VNC (remote access to the boiler control)
- Sending e-mails
7.5 Connecting the heating circuit pump (X9, X10)
Connect heating circuit pump 1 to power element connector X9 and heating circuit pump 2 to X10 .
If required (e.g. in the case of underfloor heating), connect a limiting thermostat.
If a limiting thermostat is not used, the contact must be bridged.
7.6 Electrical fusing
Fuses on the power element
Fuse Rating Size Assignment
F1 T 3.15 A 5x20 mm Fuse 230 V AC: Pre-fuse main transformer
F2 T 125 mA 5x20 mm Fuse 230 V AC: Pre-fuse standby transformer
F3 T 10 A 5x20 mm Fuse 230 V AC: Relay outputs
F5 F 8 A 5x20 mm Fuse for X18 (power supply to external modules 230 V AC)
F6 F 8 A 5x20 mm Fuse 230 V AC: Triac outputs
F7 T 2.5 A 5x20 mm Fuse 12 V AC: Heating lambda sensor
F8 T 2.5 A 5x20 mm Fuse 18 V AC: Internal electronics for main transformer
F9 T 800 mA 5x20 mm Fuse 18 V AC: internal electronics, standby transformer; display supply
F10 T 10 A 5x20 mm Spare fuse
F11 F 8 A 5x20 mm Spare fuse
F12 F 0.5A 5x20 mm
230 VAC fuse: Relay outputs X26, X27 (and X80)
and X80
Relay outputs X26, X27
and X80
Relay outputs X26, X27
and X80
F13 F 0.5A 5x20 mm Spare fuse for F12
and X80
Relay outputs X26, X27
and X80
Relay outputs X26, X27
and X80