Chapter 6: Communication Setup
SolarEdge Installation Guide - MAN-01-00060-2.6
48
►
To connect the RS485 communication bus:
1
Remove the cover from the inverter as described in the
1
Remove the cover from the inverter as described in the
1
Remove the cover from the inverter as described in the
1
Remove the cover from the inverter as described in the
2
Remove the gasket of one of the apertures in the gland communication # 2 and
2
Remove the gasket of one of the apertures in the gland communication # 2 and
insert the cable through the opening.
3
Pull the terminal connector 9-pin RS485 / RS232, as shown below:
3
Pull the terminal connector 9-pin RS485 / RS232, as shown below:
Figure 21: Terminal 485
4
Loosen the screw pine
A (+) B (-)
and
BOY WUT
on the left of the RS-485 terminal block.
4
Loosen the screw pine
A (+) B (-)
and
BOY WUT
on the left of the RS-485 terminal block.
4
Loosen the screw pine
A (+) B (-)
and
BOY WUT
on the left of the RS-485 terminal block.
4
Loosen the screw pine
A (+) B (-)
and
BOY WUT
on the left of the RS-485 terminal block.
4
Loosen the screw pine
A (+) B (-)
and
BOY WUT
on the left of the RS-485 terminal block.
4
Loosen the screw pine
A (+) B (-)
and
BOY WUT
on the left of the RS-485 terminal block.
Figure 22: RS485 terminal
5
Insert the ends of the son in the pine
G, A
and
B
listed above. Using a twisted pair cable with 4 or 6 son for this
Insert the ends of the son in the pine
G, A
and
B
listed above. Using a twisted pair cable with 4 or 6 son for this
Insert the ends of the son in the pine
G, A
and
B
listed above. Using a twisted pair cable with 4 or 6 son for this
Insert the ends of the son in the pine
G, A
and
B
listed above. Using a twisted pair cable with 4 or 6 son for this
Insert the ends of the son in the pine
G, A
and
B
listed above. Using a twisted pair cable with 4 or 6 son for this
connection. You can use any color thread for each connection
A, B
and
BOY WUT,
so that the same color thread
connection. You can use any color thread for each connection
A, B
and
BOY WUT,
so that the same color thread
connection. You can use any color thread for each connection
A, B
and
BOY WUT,
so that the same color thread
connection. You can use any color thread for each connection
A, B
and
BOY WUT,
so that the same color thread
connection. You can use any color thread for each connection
A, B
and
BOY WUT,
so that the same color thread
is used for all the pins A, the same color for all the pins B and the same color for all G. Pines
GA (Data +) B
(Data-)
RS485-2 (not used) Terminal
485
