Continue the solarcell assembly by
sliding one of the solarcells through the
slot in the middle hole.
Complete the submarine by attaching the propeller back onto the motor like in
Step 1.6
on page 4 of this manual.
9
Start threading the wire-pair
through the balance arm.
Leave
25mm (1”) slack
at the sub to
allow easier SolarEngine access.
Feed the wire through the small
holes along the balance arm. These
wires will be used to connect the
solar panels to the SolarEngine in
the next step.
4.2
Snug the wires tight from hole-to-
hole on the balance arm for a clean
appearance.
4.4
4.3
Re-attach the solarcell wires (check
Step 1.4
). You may trim any excess wire
to tidy up the installation, but you can
simply tuck excess up underneath
during final assembly.
+
-
+
-
ASSEMBLY STEPS
4.1
Thread wires through
holes and snug up
Leave 25mm (1”)
slack
