Place the vellum inside the lantern, so that
each side sits flush with the lantern shell.
S
TEP
16: S
LIDE
THE
VELLUM
PAPER
INTO
THE
LANTERN
BODY
Use some careful tweaking, and you should
be able to mount the final side to the
PumLantern without problem.
S
TEP
17: A
TTACH
THE
FINAL
LANTERN
SIDE
See those two notches on the
bottom? You need to get the tabs on
the end of your completed board in
there. Push the PCB into one slot,
then flex the other side until you can
pop the other tab into place.
S
TEP
18: P
OP
THE
PUMMER
CIRCUIT
INTO
PLACE
Before you mount your cell, you
might want to think about where
your Pumlantern will live. It may be
best for the solar cell to be attached
to one side instead of the top, so it
better catches sunlight from a
window.
Peel one side of your double-sided
sticky tape, and press it onto the
solar cell.
Then peel the other side and press it
onto the top of the lantern. All done!
S
TEP
19: M
OUNT
THE
SOLAR
CELL
www.solarbotics.com
1-866-276-2687
Page 13
