Solana DRAFT 00, Руководство пользователя

Страница: 102 / 127

remaining water from the spa. Once you are sure the internal plumbing has drained completely, set the spa flat again. Leave the
drain valve open during winterizing months
5. On standard 115 volt 15 amp models, coil the power cord and place it in the equipment compartment. On converted (hard wired) 30
amp models, make sure that the GFCI breaker inside the sub-panel remains in the OFF position during the winterization months.
6. Place the cover back on the spa and secure. Cover the vinyl cover with a large board to distribute the weight from snow and ice
evenly and to prevent breakage of the foam core.
SERVICE NOTES:
• Leave the main drain valve open approximately 1/4 turn during the winterizing months.
NOTE: Remove any debris present on the floor of the filter compartment prior to removal of the filter standpipe (debris may
enter the plumbing and block the lines). When replacing, do not overtighten.
T
O REACTIVATE
:
Reinstall the filter cartridge, close the main drain and reinstall the drain cap. Follow the Start-Up and Refill Procedures to make your
Solana ™ spa operational.
IMPORTANT: Always keep spa covered when not in use (empty or full).
Remove snow buildup to avoid breakage of the foam core from the additional weight of the snow.
36
™