SOLAC CE4502, Инструкция по эксплуатации, Страница: 9 / 64

- Without fitting the filter holder (J) (or with the
filter holder fitted, but without coffee), place a
recipient under the steamer tube (I) outlet.
- Open the Steam knob (R) turning anticlock -
wise.
- Turn the selector knob (H) to the coffee/water
position (G1).
- Water will exit through the steam outlet. Wait
until approximately one cupful has exited.
- To finish serving, return the function selector
(H) to the center position (G0) and close steam
knob (R) turning clockwise.
- This will complete the priming operation.
FILLING WITH WATER:
- The tank must be filled with water before turn -
ing the appliance on.
- Remove the water tank.
- Fill the tank taking care to observe the MAX
level.
- Replace the tank in its housing, ensuring that it
is well fitted and silicone tubes well introduced
on water tank.
FILLING COFFEE:
- Remove the filter holder (J).
- Position the selected ground coffee filter (L or
M) in the filter holder.
- Filter L (smaller one) can be used either for
ground coffee or paper pods.
- We recommend using natural toast coffee,
as using some roasted coffee may affect the
operation of the machine.
- Fill the chosen removable filter (1 or 2 cups)
with ground coffee (6-7 gr. per cup to be pre -
pared).
- Using measuring spoon (I) for 1 coffee, put 1
spoonful.
- For POD (single dose of paper), use the same
1-coffee filter, placing the well-placed mode in
the filter.
- For 2 coffees, use 2 cups filter and put in 2
spoonful.
- Next lightly press down the ground coffee with
the back of the spoon.
- Before fitting the filter holder in the coffee-mak -
er assembly, turn the ladle-holder backwards.
- Fit the filter holder in the appliance once more.
- Position the filter holder in the coffee assem -
bly by inserting the assembly downwards and
turning it anticlockwise, from left to right, until
it locks.
USE TIPS:
- 1. The filter holder must be well placed. The
correct position is with the handle slightly past
the center (Fig1). See the position of the coffee
outlet at the bottom to get an idea of the correct
position: You will notice that the coffee output is
not perpendicular to the handle (to get an idea
of the position)
- 2. The filter holder must be closed with the
machine hot. If the machine is cold, it could
happen that the closure is not correct and there
is a small loss above the filter holder.
- 3. Use the appropriate amount of coffee (Fig 2),
to be able to properly close the filter holder
- 4. Use medium-fine coffee grinding size (Fig 3).
Excessively fine can make it difficult for coffee
to escape.
USE
- Before connecting the machine, check that the
steam control (R) is closed.
- Plug the appliance into the mains.
- Start the device by pressing the ON / OFF
button F, on the back of the machine.
- The D light will illuminate, indicating that the
machine is ON and heating.
- Wait until the E indicator will light, indicating
that the correct temperature has been reached.
- Fill the filter-holder with coffee.
- Place one or two preheated cups at the outlet
of the filter holder.
- Turn the selector knob (H) to the coffee/water
position (G1)
- The unit will start with the brewing.
- When you have obtained the desired amount
of espresso coffee (short or long), return the
function selector to the center position (G0).
- Finishing the supply wait a few seconds, re -
move the cups with the coffee.
- Remove the filter holder and empty it of the
grounds.
- Wash the filter holder with running water and
dry thoroughly.
- Check that the removable filter is perfectly
placed in the filter holder.
- Reattach the filter holder to the appliance.