5.4.3 Printing Options
23
Click
on system management interface to enter printing option setting.
A. Click
to enter nozzle
maintenance setting (see Figure 31).
Nozzle
maintenance
Pre-purge
Clean
printhead
(Figure 31)
Note: 1) Pre-purge Mode: 2 modes:
both right & left nozzles;
the working nozzles only.
2) Pre-purge: four shifts: OFF, low, medium, high. see the following figures:
--Off
；
--Low
；
--Medium
；
--High
see Appendix 1: Terms and Definitions 6, 7.
B. Click
to enter printhead
setting (see Figure 32).
Printing
direction
Nozzle setting
Channel
switch
Printing
Recovery
(Figure 32)
3 Note: printing direction: system default from left to right.
1) Four directions optional: left-to-right, right-to-left, mirror sides of left-to-right and right-to-left, see figures as follows:
--Left-to-right;
--Right-to-left;
-Mirror side of left-to-right;
--Mirror side of right-
to-left.
2) channel switch: Left channel, Right channel, Dual channel, see the figures as follows:
--Left channel;
--Right channel;
--Dual channel.
3) Printing Recovery: when the set is
, printer will resume printing automatically when the power
continue. The default setting is
.
Note: When the printing contains counter, and the Printing Recovery setting is "ON", operator need to check on
the counter value and do needful adjustment.
see Appendix 1: Terms and Definitions 8.
C. Click
to enter production line
setting (see Figure 33).
Line speed
Line speed: system default 30m/min;
Adjustable scope 1~150m/min
；
DPI: system default 300DPI; adjustable
DPI
scope 50~600DPI.
Line speed
setting
Run speed
test
(Figure 33)
Содержание Elfin IC
Страница 41: ......
