Sojet Elfin IC, Руководство пользователя

Страница: 9 / 41

2.3 Cartridge Installation (42ml)
1
Step 1: Insert cartridge to
printer by an angle of 15
degree.
2
Step 2: Close the cartridge
clip to secure (see next
figure).
Cartridge removal:
Open the cartridge
clip, remove
cartridge from
printer by an angle
of 15 degree.
2.4 Position Wheel Replacement
For different substrates, there are three position wheels available (1.5mm, 2.5mm, 5mm).
The one installed on the printer is 1.5mm.
Height: 1.5mm (installed)
The best printing quality, widest ink application, high
requirement on the substrate's evenness.
Height: 2.5mm (standard)
Good printing quality, wider ink application, no special
requirement on the substrate's evenness.
Height: 5.0mm (standard)
Normal printing quality, not applicable for 3 series inks,
applicable for rough printing surface.
1. Take off the two screws
besides the reflector.
2. Take off the position wheel
and the silica gel, and replace
with the one required.
Note: While replacing the position wheels, need to change the DPI setting accordingly:
1) 1.5mm wheel corresponding DPI range 295-305
2) 2.5mm wheel corresponding DPI range 260-270
3) 5mm wheel corresponding DPI range 200-210
09