User Manual
copyright by
34
Flowpad Bedienungsanleitung
Pressure on lever to big or lever broke off
See your retailer, the remote
control probably has to be sent in
Lou Board doesn’t respond
Plug in battery and see if the
board now responds
Remote control is beeping and the board doesn’t
react normal anymore
Recharge batteries
Lou Board stops
automatically
Motor overheating
Let the motor cool down
Microcomputer of the board doesn’t react
anymore
Recharge or replace batteries
Lou Board doesn’t
drive calm and/or
unsteady
Distance between board and remote control too
big
Decrease distance
Control electronics and receiver might be moist
Dry
Not enough power
Recharge batteries
Light on the charger glows green, but board isn’t
charging
plug or charging cord damaged
Plug and charging cord needs to
be checked and possibly replaced
Light on the charger neither glows green nor red
Check plug and power supply
Lou Board can’t be
recharged
Battery can’t be fully charged, light on the
charger glows red, doesn’t change to green after
charging
Battery or charger damaged,
replace accordingly
Lamp on the charger neither glows green nor red
Check plug and power supply
Calibrate the
remote
In case, LOU remote doesn’t work properly
respectively, acceleration, break and ZERO point
are not accurate.
1.
Joystick is on ZERO position
(not acceleration and break
position)
2.
Press (long) pair/reset button
(at the back of the remote),