socomec DIRIS B-30, Инструкция по эксплуатации

Страница: 38 / 64

38 EN
DIRIS B - 546 770 A - SOCOMEC
7. STATUS AND AUTO-ADDRESSING LEDS
7.1. Status LEDs
3GDRD+$#RB@MADTRDCSNjMCNTSSGDRS@STRNESGDOQNCTBS@S@MXSHLD
The addressing button is used to automatically assign a Modbus address from the gateway.
Power supply
Addressing button
Alarm
Metrology
RS communication
LED state Fixed Blinking Pulse
ON
In operation 10 seconds - on request via a
Modbus control to identify the
CDUHBDQDLNSDRBQDDMDSB
1 second to start-up
/ALARM
M@K@QLKNFHB@K@M@KNFTDDSB
is active (does not take priority if
there is a setup alarm at the same
time)
At least one setup alarm is active
BTQQDMSRDMRNQCHRBNMMDBSDC5(
MNSBNLO@SHAKDDSB
1 second to start-up
COM
Addressing problem. Address OK 1 second to start-up and when a
frame received is processed
- - Corresponds to the metrological
pulse weight
7.2. Auto-addressing
Auto-addressing mode is used to automatically allocate addresses to products connected to the gateway. This
mode is only compatible with DIRIS B and Digiware type PMDs. The addresses will be allocated manually on the
other PMD (DIRIS A) and meters (COUNTIS).
Two modes are available:
q
Mode 1 - Auto-detection and automatic addressing
q
Mode 2 - Auto-detection and address selection
Mode 1 is without external equipment (see description below).
,NCDHRB@QQHDCNTSEQNL@/"DPTHOODCVHSG$@RXŰ"NMjF3GHRLNCDHRCDRBQHADCHMSGD$@RX"NMjFL@MT@K