11
iOS MODE
Connect Apple device in iOS Mode
Please check with your scanner application vendor or visit
www.socketmobile.com/appstore to confirm your Scanner-enabled
application supports the CHS.
Install the scanner enabled software.
If the scanner-enabled Application does
not provide instructions on how to connect with the CHS, please use the
following steps.
1. Power on the CHS. Make sure the CHS is discoverable (unpaired).
2.
To change the profile to iOS mode scan this barcode. The CHS will beep 3
times.
Use with iPad, iPod touch, and iPhones.
3. Turn Bluetooth on the Apple device. Go to Settings > Bluetooth.
A Bluetooth Devices search will begin.
4. Tap Socket CHS[xxxxxx]* in the list of Devices found. After a few seconds
the “
Not Paired
” status will change to “
Connected
” and the CHS Blue LED
will blink every 3 seconds confirming the connection.
*
The characters in brackets are the last 6 characters of the Bluetooth Address.
The full Bluetooth address is printed on the Product label in battery compart-
ment.
5.
Open the Scanner-enabled Application. The CHS will beep once indicating
that it is connected to the appropriate application.
Now you are ready to scan barcodes!
