Erwin building instruction November 2006
For glueing the lever use epoxy-glue with cotton flocks.
When fitting the lever in the correct position, notice that the
hole in the lever should be situated vertically above the hinge
line.
To connect the servos to the levers use two connectors
M2,5mm. In between, use a slightly bended welding rod
(diameter 2mm), which you solder to the both connectors.
To find the right length of the welding rod put all servos in 0-
position. If the length isn’t exact after soldering, you can heat
the soldered point with the soldering iron until the the wire
can be moved to the correct position.
To connect the cables between fuselage and wing you lead
one cable out of each part of the wing, length about 20mm,
and connect them with two plugs to the fuselage.
If the wing loosens in case of a crash, there might be tension
on the cable. To avoid this, we recommend to connect wing
and plug with a string, that is a little shorter than the cable.
If you use two seperate plugs for left and right wing, you
should mark them with colors to differentiate more easily.
www.pcm.at
11
