SNOWJOE SUNJOE SPX6000C-CT-RM, Руководство оператора

Страница: 11 / 24

11
Battery Pack Operation
NOTE: This unit is a core tool. The battery and the charger
are not included. They must be purchased separately.
The SPX6000C-CT-RM is compatible with the following
batteries (models iBAT40, iBAT40XR and iON40XRP) and
chargers (models iCHRG40 and iCHRG40-DPC).
The equipment is powered by a lithium-ion battery. The battery
pack is completely sealed and maintenance free.
Battery Charge Level Indicator
The battery pack is equipped with a push button for checking
the charge level. Simply press the push button to read off the
battery charge level from the LEDs of the battery indicator:
• All 3 level monitoring LEDs are lit: Battery charge level
is high.
• 2 level monitoring LEDs are lit: Battery charge level is
decreasing. Stop work as soon as possible.
• 1 level monitoring LED is lit: Battery is flat. Stop work
IMMEDIATELY and charge the battery. Otherwise the
battery’s service life will be greatly shortened.
NOTE: If the charge level button does not appear to be
working, place the battery pack on the charger and charge as
needed.
NOTE: Immediately after using the battery pack, the charge
level button may display a lower charge than it will if checked
a few minutes later. The battery cells “recover” some of their
charge after resting.
Charger Operation
m
WARNING!
Charge only the EcoSharp
®
iBAT40 lithium-
ion battery packs, the EcoSharp
®
PRO iBAT40XR lithium-ion
battery packs, or the EcoSharp
®
PRO iBAT40XRP lithium-
ion battery packs in compatible EcoSharp
®
iCHRG40 or
EcoSharp
®
dual port iCHRG40-DPC battery chargers. Other
types of batteries may cause personal injury and damage.
To reduce the risk of electric shock, do not allow water to flow
into the charger's AC/DC plug.
When to Charge the Battery
NOTE: The EcoSharp
®
iBAT40, EcoSharp
®
PRO iBAT40XR,
and EcoSharp
®
PRO iBAT40XRP battery packs do not develop
a "memory" when charged after only a partial discharge.
Therefore, it is not necessary to run down the battery pack
before placing it into the charger.
• Use the battery charge indicator lights to determine when to
charge your EcoSharp
®
iBAT40, EcoSharp
®
PRO iBAT40XR,
or EcoSharp
®
PRO iBAT40XRP lithium-ion battery pack.
• You can "top-off" your battery pack's charge before starting
a big job or after a long day of use.
Charging the Battery
1. Open the battery compartment cover. Slide the push lock
button on the battery to remove the battery pack from the
base unit (Fig. 12).
2. Check that the mains voltage is the same as that marked
on the rating plate of the battery charger. Then, insert the
charger's plug into the electrical wall outlet. When you
plug in the charger, the top green light will illuminate and
stay green (Fig. 13).
Charge level button
The battery is at 30% capacity
and requires charging
The battery is at 60% capacity
and requires charging soon
The battery is at full capacity
Light Indicators Lights
Fig. 12
Push lock
button