SNOWJOE iON21SB-PRO, Руководство оператора

Страница: 8 / 20

8
Discharge Chute Assembly
1. Lift the chute deflector onto the discharge chute until it
locks securely into place.
2. Insert the rubber washers between the chute and the
chute deflector on each side (Fig. 5).
3. Install the carriage bolts through the inside of the chute,
and fasten with the deflector knobs on each side (Fig. 6)
NOTE: Do not overtighten the knobs.
4. Raise or lower the chute deflector by loosening and
tightening the deflector knobs to achieve the desired snow
stream height.
Battery Pack Operation
The equipment is powered by a lithium-ion battery. The battery
pack is completely sealed and maintenance free.
Battery Charge Level Indicator
The battery pack is equipped with a push button for checking
the charge level. Simply press the push button to read off the
battery charge level from the LEDs of the battery indicator:
• All 3 level monitoring LEDs are lit: Battery charge level
is high.
• 2 level monitoring LEDs are lit: Battery charge level is
decreasing. Stop work as soon as possible.
• 1 level monitoring LED is lit: Battery is flat. Stop work
IMMEDIATELY and charge the battery. Otherwise the
battery’s service life will be greatly shortened.
NOTE: If the charge level button does not appear to be
working, place the battery pack on the charger and charge as
needed.
NOTE:
Immediately after using the battery pack, the charge
level button may display a lower charge than it will if checked
a few minutes later. The battery cells “recover” some of their
charge after resting.
Charger Operation
m
WARNING!
Charge only EcoSharp
®
PRO iBAT40XR
lithium-ion battery packs in compatible EcoSharp
®
iCHRG40
lithium-ion battery chargers. Other types of batteries may
cause personal injury and damage.
To reduce the risk of electric shock, do not allow water to flow
into the charger's AC/DC plug.
When to Charge the EcoSharp
®
PRO
iBAT40XR Lithium-Ion Battery
NOTE: The EcoSharp
®
PRO iBAT40XR lithium-ion battery
packs do not develop a "memory" when charged after only a
partial discharge. Therefore, it is not necessary to run down the
battery pack before placing it into the charger.
• Use the battery charge indicator lights to determine when to
charge your EcoSharp
®
PRO iBAT40XR lithium-ion battery
pack.
• You can "top-off" your battery pack's charge before starting
a big job or after a long day of use.
Fig. 5
Rubber washer
Chute deflector
Chute
Fig. 6
Deflector knob
Carriage bolt
Charge level button
The battery is at 30% capacity
and requires charging
The battery is at 60% capacity
and requires charging soon
The battery is at full capacity
Light Indicators Lights