SNOWJOE iON18SB-CT, Руководство оператора

Страница: 13 / 20

13
Proper Care for Battery/Charger
m
WARNING!
To reduce the risk of injury, always unplug
the charger and remove the battery pack from the charger
before performing any maintenance task. Never disassemble
the battery pack or charger. Contact your Snow Joe
®
+
Sun Joe
®
dealer or the Snow Joe
®
+ Sun Joe
®
customer
service center for ALL repairs.
1. To reduce the risk of injury and damage, never immerse
your battery pack or charger in liquid or allow any liquid to
flow inside these components.
2. Clean out dust and debris from charger vents and
electrical contacts by blowing with compressed air.
3. Use only mild soap on a damp cloth to clean the battery
pack and charger, keeping away from all electrical
contacts. Certain cleaning agents and solvents are
harmful to plastics and other insulated parts. Some of
these include gasoline, turpentine, lacquer thinner, paint
thinner, chlorinated cleaning solvents, ammonia and
household detergents containing ammonia. Never use
flammable or combustible solvents around battery packs,
battery chargers or tools.
4. The EcoSharp
®
iCHRG40 and the EcoSharp
®
SWIFT
iCHR40QC battery chargers have no serviceable parts.
Replacing the Rubber Plates
m
WARNING!
Make sure to turn off the switch and
remove the battery before performing any maintenance task
on your cordless snow blower.
NOTE:
When replacing worn rubber plates, pay close attention
to the order in which you remove the plates. Insert the new
plates in the reverse order.
1. Detach the worn rubber plate assembly by removing the 8
sets of nuts and bolts used to secure it (Figs. 20 & 21).
3. Install the new rubber plate assembly by tightening the 8
sets of nuts and bolts on both sides (Fig. 20).
Replacing the Scraper Bar
1. The scraper bar is located at the base of the snow blower
beneath the rotor housing (Fig. 22).
2. Detach the worn scraper bar from the snow blower by
removing the 4 screws that hold it in place (Fig. 23).
3. Install the new scraper bar and fasten it securely to the
snow blower with 4 screws (Fig. 22).
Fig. 20
Fig. 21
Fig. 22
Scraper bar 4 Screws
Fig. 23