SNOWJOE iON18SB-CT, Руководство оператора

Страница: 12 / 20

12
11. The LED light can be adjusted by moving it up and down
as depicted (Fig. 17).
Changing Throw Direction and
Throw Height
m
WARNING!
Never direct the snow discharge chute at
the operator, at bystanders, at vehicles, or at nearby windows.
The discharged snow and foreign objects accidentally picked
up and thrown by the snow blower can cause serious damage
and personal injury.
Always orient the discharge chute in the opposite direction
from where the operator, bystanders, surrounding vehicles, or
windows are located.
1. The discharge chute can be controlled 180 degrees by
rotating the chute with the remote switch (Fig. 18).
2. The chute deflector on the top of the discharge chute
controls the height of the snow stream. Loosen the knobs
to raise or lower the deflector to the desired height of
snow you wish to throw. Tighten the knobs to secure the
deflector (Fig. 19).
m
WARNING!
Make sure that the chute deflector locks
completely onto the discharge chute. An opening between
the discharge chute and the chute deflector may allow foreign
objects to be picked up by the snow blower and thrown in the
direction of the operator causing serious bodily injury.
• Do not advance the chute deflector too far forward as this
can cause an opening to appear between the deflector and
discharge chute.
• Do not overtighten the knobs on the chute deflector
(Fig. 19).
Maintenance
To order genuine replacement parts or accessories for the
Snow Joe
®
iON18SB-CT cordless snow blower, please visit
snowjoe.com or contact the Snow Joe
®
+ Sun Joe
®
customer
service center at 1-866-SNOWJOE (1-866-766-9563).
m
WARNING!
Make sure to turn off the switch and
remove the battery before performing any maintenance task
on your snow blower.
Lifetime Lubrication (Motor and Auger)
Lubrication is not necessary and may damage the unit. The
snow blower is lubricated for lifetime use at the factory before
shipment.
General Maintenance Tips
1. Do not attempt to repair the machine unless you have the
proper tools and instructions for disassembly and repair of
the machine.
2. Check bolts and screws at frequent intervals for proper
tightness to ensure that the equipment is in safe working
condition.
3. After each snow removal session, run the snow blower
for a few minutes to prevent the collector/impeller from
freezing. Shut off the motor, wait for all revolving parts
to stop completely, and wipe residual ice and snow off
the unit. Rotate the chute deflector by the remote switch
several times to remove any excess snow.
Fig. 17
Fig. 18
Chute remote switch
Fig. 19
Deflector knobs