16
3. Replace the worn belt with a new belt (Fig. 2
6
).
4. Place the left side cover back into position and refasten
the five (5) screws.
Replacing the Scraper Blade
m
WARNING!
Make sure to turn off the switch and
remove the battery before performing any maintenance task on
your hybrid snow shovel.
1.
Turn the hybrid snow shovel over. Using a drill or
screwdriver, remove the four screws that secure the
scraper blade to the base of the unit (Fig. 27).
2.
Remove the old scraper blade (Fig. 28).
3. Install the new scraper blade and fasten it securely to the
housing with the four screws (Fig. 29).
Lubricating the Hybrid Snow Shovel
This hybrid snow shovel does not need lubrication.
All bearings are lubricated at the factory for the life of the
product.
Storage
1.
Examine the hybrid snow shovel thoroughly for worn, loose,
or damaged parts. Should you need to repair or replace a
part, contact an authorized Snow Joe
®
+ Sun Joe
®
dealer
or call the Snow Joe
®
+ Sun Joe
®
customer service center
at 1-866-SNOWJOE (1-866-766-9563) for assistance.
2. Remove the battery from the hybrid snow shovel
before storing.
3.
Store the hybrid snow shovel indoors in a locked,
dry place out of the reach of children to prevent
unauthorized use or damage.
B Charger Off-Season Storage
1.
Do not expose your battery pack or charger to water,
rain or allow them to get wet. This could permanently
damage the charger and the battery pack. Do not use oil
or solvents to clean or lubricate your battery pack as the
plastic casing can become brittle and crack, causing a
serious risk of injury.
2.
Store the battery pack and charger at room temperature
away from moisture. Do not store in damp locations where
corrosion of terminals may occur. As with other battery
pack types, permanent capacity loss can result if the pack
is stored for long periods of time at high temperatures
(over 120ºF/49ºC).
3.
iONMAX iBAT40 lithium-ion battery packs maintain their
charge during storage longer than other battery pack
types. As a general practice, it is best to unplug the
battery charger and remove the battery pack when they
are not in use. Recharge the battery pack every 6 months
to 50% capacity (2 lights on) during off-season storage to
maintain optimal battery performance.
Fig. 26
Belt
Fig. 27
4 screws
Drill
Fig. 28
Scraper blade
Fig. 29
Scraper blade
4 screws
Содержание iON13SS-HYB
Страница 20: ...snowjoe com...
