Lit. No. 76454/76455/76456, Rev. 03
16
February 15, 2020
LUBRICATION
To keep your spreader running smoothly, lubricate
bearings after every 20 hours of use.
AFTER EACH USE
•
Wash out the hopper and rinse off all external
surfaces.
• Apply dielectric grease on all electrical
connections to prevent corrosion.
MAINTENANCE
STORAGE
Store control in a cool dry place during the off-season.
At the End of Each Season or After
Extended Storage
•
Wash out the hopper and rinse off all external
surfaces.
• Apply dielectric grease on all electrical
connections to prevent corrosion.
•
Lubricate all grease fittings with good quality
multipurpose grease.
• Oil or paint all bare metal surfaces.
• If motor cover is removed for any reason, use
silicone sealant to ensure weatherproofing of
enclosure.
•
After first use, tighten all fasteners on spreader
and mount.
FUSE REPLACEMENT
If a problem should occur and fuse replacement is
necessary, the replacement fuse must be of the same
type and amperage rating as the original. Installing a
fuse with a higher rating can damage the system and
could start a fire.
WARNING
Never remove spreader with material in hopper.
CAUTION
• When replacing parts use only original
manufacturer's parts. Failure to do so will
void warranty.
• The control is a solid state electronic unit
and is not serviceable. Any attempt to
service will void warranty.
• There are no serviceable parts in the
motor/transmission assembly. Any attempt
to service will void warranty.
• Spinner motor is not designed for
continuous duty. Allow motor to cool
between long cycle times.
• When pressure washing motor enclosure
area, keep spray at least 36" away from
motor enclosures.
CAUTION
Disconnect electric power at spreader
electrical wiring harness connection and
tag out, if required, before servicing or
performing maintenance.
