SnowEx RDV V-Plow, Руководство механика

Страница: 31 / 84

Lit. No. 30118, Rev. 00 June 15, 2020
31
Distributor Master Control
The Distributor Master Control (PN 78800) can
clear an established code in a snowplow module
without using the original control that was used
to establish the code. This procedure should also
be used to reset the module if the security code
is unknown.
IMPORTANT: The following steps must be
performed using the Distributor Master
Control. Only the Distributor Master Control is
programmed to clear an established security
code when the original control used to
establish the code is not available.
1. Turn the vehicle ignition to the "OFF" position.
2. With the control power OFF, using the tool that
was included in the Distributor Master Control
box, place the tool over the keypad, and push
down on the plate.
NOTE: The only button that should be exposed
is the LOWER button. All other buttons should
be engaged and pressed down.
WARNING
To prevent accidental movement of the
blade, always push the ON/OFF button
to switch the control OFF whenever the
snowplow is not in use. The power indicator
light will turn OFF.
AIS
LOWER
ON/OFF FLOAT
Position the Master Control Plate on the keypad
so that only the LOWER button is exposed.
Master
Control
Plate
LOWER
Button
Keypad
3. Pushing the tool down will engage all functions
except LOWER. While pushing down on the
plate, turn the vehicle ignition ON.
4. When the ignition is turned to the "ON"
position, the system will reset and the security
code associated with the snowplow will be
cleared.
FLEET FLEX ELECTRICAL SYSTEM
SECURITY GUARD™ SNOWPLOW ANTI-THEFT SYSTEM, continued