SnowEx RDV V-Plow, Руководство механика

Страница: 29 / 84

Lit. No. 30118, Rev. 00 June 15, 2020
29
Activation & Establishing a 4-Digit
Security Code
NOTE: The snowplow must be attached to the
vehicle and all the electrical connections must
be connected prior to activating the security
code function.
1. Turn the vehicle ignition switch to the "ON" or
"ACCESSORY" position. (It is not necessary to
start the vehicle.)
2. Verify that the control power indicator is OFF.
If the power indicator light is red, the control is
ON. Turn the control OFF.
3. To activate the SECURITY GUARD mode,
move the control lever to the #1 position or
press the #1 button four consecutive times,
and then move the lever to the #4 position or
press the #4 button four consecutive times
(sequence: 1, 1, 1, 1, 4, 4, 4, 4). The green
FLOAT light will
fl ash quickly and the red
power indicator light will turn ON, indicating
that the system is ready to accept your 4-digit
security code.
Enter your 4-digit security code by moving
the control lever to (or pressing the button for)
any four of the eight following positions: UP,
DOWN, LEFT, RIGHT, 1, 2, 3, or 4.
Once you have entered your security code, the
FLOAT light will stop
fl ashing and the power
indicator light will turn OFF. This indicates that
your security code is entered and stored in the
SECURITY GUARD system.
4. Once a 4-digit security code is established,
the SECURITY GUARD system will recognize
any FLEET FLEX control that has been
programmed with the same 4-digit security
code. If a control not programmed with the
correct 4-digit security code is connected to
the system, the established security code
will have to be entered manually before the
snowplow can be activated (see the Manual
Unlock procedure).
NOTE: If the control is turned ON prior to
completing the programming procedure, your
4-digit security code will be cancelled.
Manual Unlock
If the SECURITY GUARD system is activated
and you are using a FLEET FLEX control with a
di
ff erent 4-digit code than the established security
code, you will be required to manually enter the
4-digit security code before operating a locked
snowplow.
1. Turn the vehicle ignition to the "ON" or
"ACCESSORY" position.
2. Turn the control ON.
3. The power indicator light will fl ash rapidly,
indicating that the snowplow is locked.
4. Enter the 4-digit security code.
5. After the correct security code is entered, the
power indicator light will change from fl ashing
rapidly to a solid light to indicate that the
snowplow has been successfully unlocked.
NOTE: If the plow/vehicle electrical connection
is lost or disconnected, the SECURITY GUARD
system will reset, requiring any FLEET FLEX
control that is not programmed with the
established 4-digit security code to manually
re-enter the security code to activate the
snowplow.
SECURITY GUARD™ SNOWPLOW ANTI-THEFT SYSTEM
FLEET FLEX ELECTRICAL SYSTEM