4
16992200 Rev E
JACK PLATE
DISMOUNTED PLOW
<---
FOOT PEDAL
CROSS BAR
RECEIVER
NOTCH
MOUNT PIN
LIFT FRAME
CHAIN LIFT
JACK
MOUNTED PLOW
LOCK PIN
MounT/DIsMounT InsTRuCTIons
snowplow Mounting
(fig. above)
1.
Check that the pins are fully retracted. The foot
pedal should be pushed towards the truck and will
lock in the retracted position.
2.
Drive in to the plow so that the cross bar on
the mount engages with the receiver notch on the
plow. Depending on the plow height the jack many
need to lowered or raised to fully engage.
3.
Pull the foot pedals away from the truck to
release the pins.
4.
Push up on the lift frame to engage the pins. The
gold pin will be visible to verify pull connection.
Insert the lock pin (or padlock) through the foot
pedal and pedal linkage.
5.
Retract the jack enough to allow its removal.
Rotate the jack to disengage from the jack mount
plate.
6.
The jack may also be stored in the truck for
added theft prevention.
7.
Connect both the lighting & hydraulic connectors.
snowplow Dismount
(fig. above)
1.
Put the plow in float by holding the down button
for 1 second.
2.
Press down on the chain lift to retract the lift
cylinder. The chain must have slack for ease of
plow removal.
3.
Install the jack into the jack mount plate. This
will raise the lift frame prop.
4.
Extend the jack enough to remove weight from
the plow mount pins.
5.
Push on the foot pedals and raise the lift frame
simultaneously. The pins will retract and the lift
frame will rotate forward to rest on the lift frame
prop.
6.
Disconnect the lighting and hydraulic connectors
7.
Back away from the snowplow