Snow Peak SD-180, Инструкция по эксплуатации

Страница: 17 / 24

Ridge pole
Main pole
To pull
To pull
Puller
Hold the tape on the floor sheet side with one hand
and pull the puller with the other hand.
Fly sheet
(the shiny side)
Logo
Spread the flysheet so that the logo looks inverted.
This will be the left side of the tent when set up.
16
5
4
Spread the fly sheet next to the floor sheet with the inside of the fly sheet (the shiny side) facing up.
Bring the part where the logo is printed (It will be the left side of the tent when set up) close to the
floor sheet, and connect the buckles at both corners of the short side to the buckles at the corners
of the floor sheet.
* At this time, check that the tape with the buckle is not twisted.
Pull the tape pullers at the four corners of the floor sheet toward the center of the floor sheet until
the end. The pole will stand up in the shape of a tent.
※If the pole does not come up after pulling at one point, lift the center of the pole upward gently by
hand. Pulling the tape forcibly at the four corners when the pole is not up may damage the pole.
※IMake sure the ridge pole is over the main pole.