Snow Peak SD-180, Инструкция по эксплуатации

Страница: 16 / 24

Quilted side
Pole
Tip of the
pole
Grommet (hole)
Joint
Insufficient
connection
Connection
completed
Position the frame so that the
left and right joint holes face up.
15
Setup procedure
1
2
3
Please follow the instructions below to set up and disassemble the tent, and practice repeatedly to
prepare for actual use. Also, please make sure that all accessories are included. Forcibly setting up and
disassemble the product may result in damage to the tent or pole, or an accident. Please read this
manual carefully before using the product.
Take the tent out of the carry case and
spread the floor sheet on the ground so that
the quilted side with the woven logo is on top.
Also, make sure that the adjustment tapes at
the four corners are fully extended.
Connect the joints of the pole and place it in the center of the floor sheet.
※Connect the pole firmly until the joints of each section are not visible. If the connection is insuffi-
cient, the pole may be damaged.
Extend the tape with grommets (holes) at the four corners of the floor sheet and insert the tips of
the pole into the grommets.
※Make sure the tape is not twisted at this time.