Snow Peak GigaPower WG STOVE, Инструкция по эксплуатации, Страница: 22 / 23

22
When performing the maintenance measures below, please refer to the
illustrations on page 9.
1. Cleaning the burner
While cooking, the burner may become clogged from the overflowing
liquids. Therefore, clean the burner on a regular basis.
Procedure: Remove the flat countersunk head screw M4 located in the
center of the burner. Use a wire brush to remove dirt and/or corrosion from
the wave and doughnut plates. Be careful to reassemble the stove in the
correct sequence. If not reassembled properly, improper burning may
result.
2. Greasing the Piston
A high-performance maintenance grease has been used to lubricate the
piston. However, with use of the product, wear-and-tear is unavoidable. The
shaft may become resistant to pumping as a sign of such wear-and-tear.
Therefore, regularly clean and grease the piston.
Procedure: Remove the pump cap’s pan-head screw M2.5 and the shaft.
Wipe off the soiled grease and apply a thin layer of the supplied
maintenance grease on the O-ring and shaft.
3. Inspection of seal gaskets
Over time, the sealing gaskets will deteriorate even if the stove is not being
used.
Procedure: Thoroughly inspect the gaskets for signs of deterioration (i.e.,
cracks). If deterioration is suspected, replace the gaskets, being careful to
remove all excess dirt and foreign matter.
4. Inspection of O-rings
Even if the stove is not in use, the O-rings on both ends of the fuel hose
will deteriorate over time.
Procedure: Thoroughly inspect the O-rings on either side of the fuel hose
for signs of deterioration (i.e., cracks). If deterioration is suspected, replace
the O-rings, being careful to remove all excess dirt and foreign matter.
Apply a thin layer of the supplied maintenance grease, then cover with the
protective cap after O-rings have been changed.
5. Cleaning the needle
The output power of the stove will decrease when the needle is dirty.
Procedure: If the tip of the needle becomes dirty clean it with the supplied
scotch pad.
A clogged jet is cleaned by completely opening the flame control
(turning clockwise ).
8. Maintenance