Snorkel ATB 42, Руководство оператора

Страница: 72 / 87

10. Stowing and Transporting
■
Stowing
At the end of each work day (or in preparation for
lifting or storage) a qualified operator should put
the ATB 42/50 into its stowed position then lock it.
The correct stowed position is shown here.
To bring the ATB 42/50 into the stowed position
use the controls on the ground control box or
platform control box to:
1. Fully retract the booms (ATB 50 only).
2. Fully lower the booms.
3. Center the main boom between the rear
wheels.
❑
To Lock the ATB 42/50:
If the engine has just been under load and is
hot, let the engine idle for one minute.
1. Set the Master Key Switch to OFF then
remove the key.
2. Set the Battery switch to OFF and it.
3. For machines equipped with optional LPG
fuel, close the valve on the LPG tank
(completely turned clockwise).
4. Close and lock all doors.
■
Transporting
❑
Trailering
An ATB 42/50 weighs approximately 15,280
pounds (6930 kg). Loading ramps must be able to
support that weight. Transport trailers must be
able to safely transport that weight.
DO NOT load an ATB 42/50 on grades over
25%; or with the turntable rotated with respect
to the chassis; or on ramps with poor traction,
uneven surfaces, or steps.
To safely drive an ATB 42/50 onto a transport
trailer:
1. Visually inspect the alignment of the loading
ramp (1) and the truck or trailer (2). They
should both be on the same straight line.
2. Chock (3) the wheels of the truck or trailer so
it cannot roll away form the loading ramp (1)
while the ATB 42/50 is being loaded.
3. Set the ground control box for platform
operation.
ATB 42/50 – 0161987 page 10 - 1
DANGER
Courtesy of Crane.Market