Installing your Snooper S2 using the Hook and Loop fastener
The Snooper S2 can be installed anywhere on the dashboard as long as the
built-in GPS antenna has a clear view of the sky and you can easily see the
LED display and operate the controls safely. You will also need to be sure
that you can connect the power connection cable. Your S2 can be installed
easily with the hook and loop fastener if you have a sufficiently flat area on
your dashboard. Follow these instructions to mount the control panel in this
way.
•
Use a damp cloth to thoroughly clean the bottom of the S2 and the area
where you intend to mount your unit.
•
With the two parts of the Hook and Loop fastener still fastened together,
peel the backing tape from the softer ’Loop’ side of the fastener and apply
it to the bottom of the unit.
•
Next remove the backing tape from the ’Hook’ side of the fastener, again
whilst the two parts are still fastened and position the unit onto the desired
area. If possible leave the Hook and Loop fastener for 24hrs to adhere
properly before using regularly.
•
Finally plug the smaller plug on one end of the power cable into the socket
marked DC12V on the back off the S2 and plug the larger plug into the
cigarette lighter socket of your vehicle. Your Snooper S2 is now ready for
use. For further information please read the section on Power Connection
on page 10.
INST
ALL
ATION
INST
ALL
ATION
9
Return to Contents Page
