Sno-Way HTV200000, Руководство пользователя

Страница: 9 / 30

8
3. With the blade in “scoop” position, push the snow
plowed to the edge of the path to the edge of the lot and
“stack” it in a pile.
4. If the snow plowed to the edge of the path is too large
to push the entire pile to the edge of the lot, fill the blade,
in “scoop” position, and then push the pile over into the
cleared path and then to the edge of the lot. Then return,
and with the blade in “scoop” position, push the remain-
ing row of plowed snow to the edge of the lot.
5. When “stacking” snow, pushing the plow filled with
snow into the existing pile will usually cause the plow to
raise somewhat as it goes into the pile allowing the
“stack” to be built higher.
6. If the snow in the lot is deep and/or hard packed,
plow all the paths through the lot with the blades in the
"V" position. This will put less sideload on the vehicle and
will make plowing the paths easier.
Mounting Snow Plow To Vehicle
1. Plow must be on a level surface, supported by the
jack stand. Drive truck towards plow and align lugs on
plow to fit inside the lugs on each side of the truck sub-
frame. Continue to pull forward towards plow until the
plow lugs ride up into position on the sub-frame inserts
located between the sub-frame lugs.
2. Remove the protective plastic covers from the snow
plow and vehicle harnesses and store them inside the
vehicle for installation when the plow is removed.
3. Connect the plow end of the power harness to the
vehicle end of the power harness.
4. Remove the hand-held controller from the vehicle to
use it near the plow while mounting the plow to the
vehicle. Disconnect the hand-held controller from the
harness at the connector inside the vehicle. Connect it to
the connector at the end of the plow control harness.
Turn the hand-held controller on after connecting it to the
plow control harness.
5. If needed, the hand-held controller can be used to
raise or lower the A-frame to precisely align the pinholes.
To raise the plow, press the ’UP’ function on the
controller. To lower the plow, turn on down pressure and
press the ’LOWER’ function. The ’UP’ function must be
pressed to stop the downward motion once it begins. To
lower plows without down pressure, place the plow in
WARNING
Be sure all plow functions are OFF on ALL plow
controls in the vehicle cab before making ANY
electrical connections.
FAILURE TO HEED CAN RESULT IN SERIOUS
INJURY OR DEATH.
WARNING
• Ensure engine is OFF and set parking brake
before mounting snow plow to vehicle. Vehicle
movement, equipment failure, or inadvertent
operation of the control switches during installa-
tion could result in serious injury.
• NEVER place fingers in A-frame or mount lug
holes to check alignment. Sudden motion of the
plow could severely injure a finger.
FAILURE TO HEED CAN RESULT IN SERIOUS
INJURY OR DEATH.
WARNING
The power cable on the front of the truck is wired
directly to the battery. The power cable is always
energized, even if the truck is turned off. Always
replace the protective cap after disconnecting
the plow power cable. Allowing an unprotected
plug to contact metal parts of the truck may
cause electrical component damage. Never use
a metal object to clean the plug contacts.
FAILURE TO HEED CAN RESULT IN SERIOUS
INJURY OR DEATH.
WARNING
When using the hand-held controller to raise or
lower the plow A-frame for mounting the plow to
the vehicle, be especially careful of the
movement of the light bar, if so equipped. This
movement will occur when raising or lowering
the A-frame on the jackstand.
FAILURE TO HEED CAN RESULT IN SERIOUS
INJURY OR DEATH.