Sno-Way 29VSKD SERIES, Инструкция по установке и эксплуатации

Страница: 12 / 20

11
Removing Snow Plow From Vehicle
1. Lower the snow plow to the ground.
2. Disconnect the hydraulic hoses and electric
connector from the vehicle.
3. Unlock the universal mount from the snow plow and
slowly back the vehicle away, while tilting the universal
mount slightly forward.
Plow Adjustment
1. The plow frame height should be adjusted relative to
the optimum resting position of the loader arms. To
adjust, remove the locknuts and hex head cap screws
that secure the rear of the A-frame to the mounting lugs
of the universal adapter. Move the A-frame to a higher or
lower position as required and re-install the capscrews
and locknuts. Tighten securely.
2. This plow is equipped with the MaxAdjust
TM
System
(Patent pending). Adjust capscrew as required to position
center of moldboard at a 90° angle to the ground. (See
Figure 1-14).
Figure 1-14
3. This plow as an option has 4 shoes that may be
installed to help with gravel plowing and aid in over all
cutting edge wear. Two plow shoes are located at the
outboard end of each wing. The two inner plow shoes are
located inboard on the wing underneath the cylinder
mounting area.
IMPORTANT:
To ensure the best function of this
Snow Plow, it is a requirement that all four plow
shoes be adjusted equally.
Adjust the plow shoes as follows:
a. Park the vehicle on a smooth level surface. Adjust
the wings straight out on each side and lower the
plow to the ground.
b. When properly adjusted, the plow shoes and
wearstrips contact the ground at the same time.
Determine whether the plow shoes or wearstrips
are off the ground.
• If the plow shoe(s) were off the ground - washers
must be moved from the top to the bottom of the
shoe stem.
• If the wearstrips are off the ground - washers
must be moved from the bottom to the top of the
shoe stem.
c. Raise the plow and place suitable blocking under
the plow to allow at least six inches (6") of
clearance from the bottom of the plow shoes to the
ground.
d. Lower plow onto blocking. Turn ignition switch OFF
and apply the emergency brake.
e. Adjust shoe assemblies by removing shoe mounting
lynch pin and adding or subtracting washers on the
top or bottom of the shoe mounting location. (See
Figure 1-15).
Figure 1-15
PLOW
TILT ADJUSTMENT
CAP SCREW
90°
MARKER
WARNING
Keep hands and feet clear of wings and center
section when setting blocking and lowering
plow. Moving or falling assemblies could result
in serious injury.
FAILURE TO HEED CAN RESULT IN INJURY
OR DEATH.
WASHERS
PIN