Sno-Way 29VSKD SERIES, Инструкция по установке и эксплуатации

Страница: 11 / 20

10
10. Attach a plow marker to each wing as shown and
secure using 5/16" x 1" cap screws and locknuts. (See
Figure 1-10)
Figure 1-10
11. Loosely connect hydraulic hoses to the wing
cylinders. (See Figure 1-11).
Figure 1-11
12. Loosely position hydraulic hoses in hose clamps (A -
5/16" X 2" self-tapping screw, B - plate, C - clamp blocks)
on each side of the A-frame.
13. Adjust each hose length from clamps to hose end
fittings to 33 in. and tighten both clamp screws. (See
Figure 1-12)
NOTE: If installing screw with an impact wrench, ensure
that the wrench in adjusted to its lowest torque setting to
avoid fastener damage.
Figure 1-12
14. Tighten all hydraulic hose fittings securely.
Mounting Snow Plow To Vehicle
1. Drive up to the snow plow and tilt the universal mount
slightly forward.
2. Hook the top of the universal mount under the lip on
the skid steer adapter plate of the snow plow.
3. Position the snow plow so that it rests flush against
the universal mount and lock the snow plow in place.
4. Connect the hydraulic hoses (V1, V2 and CD) to the
auxiliary hydraulic connectors on the vehicle. Refer to
figure below and the hydraulic schematic on page 14.
Figure 1-13
5. Connect the electrical connector to the vehicle.
5/16" x 1"
CAP SCREWS
PLOW
MARKER
A
B
C
D1
R1
R2
D2
33"