IQSDA34
www.snellgroup.com
Controlling the IQSDA34 from the RollCall Control Panel
Issue 2 Rev 3
Page 20
©
2015 Snell Limited
5.5 RollTrack
The RollTrack screen allows information to be sent, via the RollCall™ network, to other
compatible units connected on the same network.
Use the settings on the RollTrack screen to:
•
Enable or disable the RollTrack functions.
•
Configure up to 16 RollTrack outputs.
•
Specify the conditions that trigger RollTrack data transmission.
•
Set RollTrack destinations.
•
Specify the RollTrack commands to be sent.
.
5.5.1 Disable All
When checked, all RollTrack items are disabled.
5.5.2 RollTrack Index
The slider enables up to 16 RollTrack outputs to be set up. Dragging the slider selects the
RollTrack Index number. Clicking the
P
button selects the default preset value.
5.5.3 RollTrack Source
This slider enables the source of information that triggers the transmission of data to be
selected. Dragging the slider selects the RollTrack source, displayed below the slider. Clicking
the
P
button selects the default preset value. If no source is selected,
Unused
is displayed.
Unused
No RollTracks sent.
Input N OK
Valid serial data input received.
Input N None
No serial data input received.
Input N Bitrate 270
Received bitrate is 270 Mbit/s.
Input Bitrate 1.5
Received bitrate is 1.5 Gbit/s.
Input N Bitrate 3G
Received bitrate is 3 Gbit/s.
Input N Bitrate Un.
Received bitrate is unknown.
Using Config 1
Configuration 1 is selected.
Using Config 2
Configuration 2 is selected.
Using Restart Conf
Restart configuration (3) is selected.
