Not for
Reproduction
5
800X Series Zero-Turn Rider - 61” & 72” Mower Deck
Roll Bar Assembly
Assemble Retainer Pins
1. Unpack the roll bar and hardware from the box.
2. Assemble the foam ring (
A, Figure 6
) onto the retainer
pin (
B
).
3. Loop the snap end of the lanyard (
C
) through the retainer
pin handle and snap together.
4. Install the lanyard anchor (
D
) onto the lanyard.
5. Install the clevis pin (
E
) onto the loop end of the lanyard
as shown in Figure 6.
Figure 6. Assemble the Retainer Pins
A. Foam Ring
B. Retainer Pin
C. Lanyard
D. Lanyard Anchor
E. Clevis
Pin
A
B
C
D
E
Figure 7. Assemble the Top Loop
A. Top Loop Tube
B. Plastic Cap
C. Rubber Stop
A
B
C
Assemble the Top Loop
1. Install the plastic cap (
B, Figure 7
) into the end of the
top loop tube (
A
). Repeat for other end of tube.
2. Make sure the rubber stop (
C
) is properly seated against
the inside of the pivot mount. See Figure 7.
Snap End
Loop End
Figure 8. Install the Upright Tubes
A. Roll Bar Sockets
B. Upright Tube
C. 1/2” x 3-1/4” Bolt, 1/2” Flat Washer & 1/2” Nylock Flange
Nut (not shown)
Install the Roll Bar
1. Make sure the roll bar sockets (
A, Figure 8
) are clear of
any obstructions, wires, foreign objects, etc.
2. Install the roll bar upright tubes (
B
) into the sockets.
Loosely Install the 1/2-13 X 3-1/4” hex head bolts and
1/2-13 hex side lock nuts (
C
).
3. Repeat steps 1 and 2 for the other side of the machine.
Rear View
C
B
A
B
