Snapper WMRP216517B, Инструкции по безопасности и руководство оператора

Страница: 19 / 28

19
Section 4 - ADJUSTMENTS & REPAIR
WARNING
DO NOT attempt any maintenance, adjustments or
service with engine and blade running. STOP engine
and blade. Disconnect spark plug wire and secure
away from spark plug. Engine and components are
HOT. Avoid serious burns, allow sufficient time for
all components to cool. Wear heavy leather gloves
when handling or working around cutting blades.
Blades are extremely sharp and can cause severe
injury. DO NOT use a cutting blade that shows signs of
excessive wear or damage.
4.4.1. Engine Drive Belt Replacement
(Stretch Type Belts)
(Continued From Previous Page)
IMPORTANT: Drain fuel tank before tipping mower.
DO NOT tip machine with carburetor or spark plug down.
Oil from crankcase will saturate the air filter and cause the
engine to be hard to start or not start at all. If
contamination does occur, the air filter will have to be
replaced.
3. Remove the driven disc. Refer to Section
“Replacing Rubber Driven Disc Ring” for driven disc
assembly removal procedure.
4. Tilt mower up on its rear wheels and remove
blade and blade hub. Assistance from another
person may be necessary to hold mower in the
tilted position.
5. Hold the slotted end of the drive disc bolt with a
screwdriver and remove the nut and internal tooth
lock washer. See Figure 4.16.
6. Remove the belt cover located under deck.
7. Lift the drive disc up and remove worn belt.
8. Loop one end of new belt over engine pulley and
insert the other end through slot in deck. See Figure
4.15.
PULLEY POSITION
FIGURE 4.16
9. Loop the belt around the pulley on the bottom of
the drive disc.
10. Reinstall drive disc and retaining hardware.
IMPORTANT: 1) The square shoulder of the drive
disc bolt must fit into the square hole of the
bushing. 2) The square end of bushing must fit into
the bracket slot.
11. Reinstall belt cover and tighten bolts securely.
12.
Reinstall blade hub and cutter blade.
Recommended torque for blade cap screw is 40 ft. lbs.
4.4.2. Transmission Poly-V Belt Replacement
1. Remove the driven disc. Refer to Section
“Replacing Driven Disc Rubber Ring” for procedure.
2. Note the routing of the old belt around the three
pulleys before removing it. See Figure 4.17.
3. Place new Poly-V Belt over end of hex shaft and
onto driven pulley.
4. Work belt onto top of idler pulley.
5. Twist belt sideways and pull it upward between
the differential bracket and drive pulley and then
down into the pulley groove. Make sure the Poly-V
Belt is above belt guide. See Figure 4.17.
FIGURE 4.17
DRIVE DISC
SLOT IN END
OF DRIVE DISC
BOLT
BUSHING
BOLT RETAINER
DECK BRACKET
(PARTIALLY SHOWN)
INTERNAL TOOTH
LOCKWASHER
NUT
DRIVE
PULLEY
HEX SHAFT
BELT GUIDE
DRIVEN
PULLEY
POLY-V
BELT
DIFFERENTIAL
BRACKET
IDLER
PULLEY
ROUTING OF POLY-V-BELT