Snapper FAST-Vac, Руководство оператора с инструкциями по настройке, Страница: 15 / 24

13
Installation
GB
Collector Installation
Install Collector Bags
1. Raise the collector hood and slide the collector
bags (A, Figure 22) onto the frame rails (B).
2. Lower the hood and push the lock pin (D) through
the hood lock plate (C).
IMPORTANT NOTE: The collector bags are
constructed with three mesh panels and one solid
panel. Install the bag with the solid panel towards the
front of the machine.
Figure 22. Install the Collector Bags
A. Collector Bag
B. Frame Rails
C. Hood Lock Plate
D. Lock Pin
A
B
B
D
C
Figure 23. Install Weight Carrier
A. Weight Carrier
B. Clamp
A
Figure 24. Weight Carrier
A. 3/8-16 x 1-1/4” Bolts
B. 3/8” Washers
C. 3/8-16” Nylock Flange Nuts
D. Counter Weights
E. Retaining Pin
F. Hairpin Clips
E
F
D
B
A
C
B
Weight Mount Installation
I. Position the weight carrier (A, Figure 23) onto the
front of the unit so that the weight carrier is center
from side to side and 3" (7.62 cm) from the top
edge of the foot plate. Clamp (B) the weight carrier
into place.
2. Drill two (2) 3/8" holes through the foot plate using
the holes in the weight carrier as a guide. Secure
the weight carrier into place using two (2) 3/8-16 X
1-1/4" bolts (A, Figure 24), 3/8 flat washers (B)
and 3/8-16 nylock flange nuts (C).
3. Install the counter weights (D, Figure 24) in the
weight carrier and secure with the retaining pin (E)
and the hairpin clips (F).
3” (7.6 cm)